Neoprene Rubber Screw-in Auto-Leveling Bumper - 1-1/2" OD x 1/2" Thick (3/8-16 x 1-3/16" L Swivel Stud)

Neoprene Rubber Screw-in Auto-Leveling Bumper - 1-1/2" OD x 1/2" Thick (3/8-16 x 1-3/16" L Swivel Stud) will screw into any 3/8-16 female thread or mount through a 3/8" diameter hole and secure with a nut. A great turnkey way to add a rubber bumper as a non-slip foot or impact surface where needed! The bumper pad itself swivels 360" independently of the stud, and tilts slightly in any direction to help insure full contact with uneven surfaces.

Features

Made of tough black neoprene rubber with a ribbed face for extra grip.

Outside Diameter: 1-1/2" Nominal - 1.495" Actual Measured.

Thickness: 1/2" Nominal - .525" Actual Measured.

Stud Thread: 3/8-16 course thread.

Stud Length: 1-3/16" Nominal - 1.170" Actual Measured.

Zinc plated stud can be mounted by screwing into a 3/8-16 female thread, or through a 3/8" hole backed by a 3/8" nut.

Rubber bumper pad will swivel 360 degrees and will tilt slightly in any direction, independently of the stud.

Stud has a hex head, located underneath rubber pad that requires a 9/16" wrench to allow tightening.

Great for adding non-slip floor feet that will accommodate an uneven surface.

Bumpers may be mounted in any position where a soft stop is desired.

Mounting multiple bumpers will insure each one makes full contact with floor surface for greater positive grip.

- Photo shows more than one for display purposes only.