2" x 2" PVC External End Caps (Foot Stops) - 50 degree Offset End

2" x 2" PVC External End Caps (Foot Stops) - 50 degree Offset End Made of flexible PVC, combined with a non-slip texture, it it recommended a hammer or rubber mallet be used to install these over the ends of 2" square tubing. While one end of this external cap has a 50 degree offset angle it is not required nor advised to cut a matching angle on the tube ends. The reason for this is because a square cut (or angle cut) tube end will bottom out approximately 2" deep into the cap itself. Bear in mind that installing these foot stop caps will add approximately 2" extension to the end of the 2" square tube. For Example: If you need a base member to have an overall length of 20" with these caps installed at both ends, then your base member should be cut 16" long prior to cap installation.

Features:

Made of pliable (flexible) PVC with non-slip texture on both sides & bottom

Fits extremely tight over the end of tubing and won't fall off due the non-slip "rubbery" material

Outside Dimensions: 2.525" High x 2.470" Wide x 4" Long

The end of 2" square tube will bottom out at 2" deep inside cap

Offset angle of outer end of cap is 50 degrees

Cap will lift frame off floor .230" to increase stability and help prevent annoying frame rocking

A tube with a 90 degree cut will install 2" deep into cap

A tube with an angle cut on the end will NOT install any deeper into cap vs. a standard 90 degree square cut

Offset Caps will give framework a polished modern stance with with a super heavy duty flavor to the appearance

The steep 50 degree offset outer face gradually transitions to the floor surface thus, lessening the chance of tripping passers by

The top and offset face of cap have pronounced ridges as shown in photo

This is our top-of-the-line foot stop all things considered!

- Photo shows more than one for display purposes only