Prefab "J" Bar Catches - 2" wide x 8-1/2" Tall - 15 degree Slant (sold individually)

Prefab "J" Bar Catches - 2" wide x 8-1/2" Tall - 15 degree Slant. If you fabricate your own equipment, these are a real time saver. In fact, most fabricators do not have a bead roller that is capable of beading 3/16" plate. The bead not only stiffens up the part significantly, it also makes it so the bar contact is minimized with the catch. This preserves the finish and makes it easier to position the bar before starting an exercise set. This part is stamped and is in raw form, meaning it has not been cleaned and deburred. The 2" width throughout allows welding to 2" x 2" square tube uprights. The catch upright is angled 15 degrees to help minimize bar "spring back" when racking the bar hard and thus, lessening the chance of the bar bouncing over the front lip. This component is used by fitness manufacturers around the globe who need a very strong, heavy duty bar catch.

Features:

Material: 1018 Mild Steel - bare mill finish

Material Thickness: 3/16"

Width: 2"

Length of Catch Upright (Inside): 8-1/4"

Length of Catch Upright (Outside): 8-1/2"

Angle of Catch Upright: 15 Degrees

Length of flat bottom (Inside where bar rests):2-3/8"

Length of flat bottom (Outside):2-3/4"

Length of front lip (Inside where bar makes contact): 1-1/4"

Length of front lip (Outside): 1-1/2"

1" wide rolled bead entire length adds incredible strength to resist bending or flexing

Sold Individually

Each catch weighs 608 grams (approx. 1 lb 5 oz)