7.5" Long x 1.5" I.D. - High Density Rubber Handle Grip - (Closed One End)

7.5" Long x 1.5" I.D. - High Density Rubber Handle Grip - (Closed One End)

These are the same grips typically used on exercise equipment handle bars to provide a non-slip surface with a soft touch. Slip this grip onto any 1.5" diameter bar stock or pipe. If installing onto pipe, be sure that end is capped of to prevent loss of air during installation. These grips have one end closed off. During installation, an air pocket forms to keep an air gap between handle grip and bar. Without this air pocket, the grip will contract and won't move. You may "roll" it off and try again without damage to the grip. You may use end caps, such as those offered on our "caps & Plugs" section, to close off the end of pipe before attempting grip installation.

Features

Inside Diameter ("A" Dimension): 1.5" - This should match the bar diameter without the grip is installed

Inside Length ("B" Dimension): 7.5"

Made of High Density Rubber - Soft to touch, yet firm to grip - not "spongy" like foam rubber.

Closed-cell structure - won't absorb fluids - easy to clean

Non-slip textured surface for a confident grip

Installs easily over the end of smooth shaft surface using rubbing alcohol or saliva as a lubricant

Ask about large quantity discounts

Keep your equipment looking brand new by replacing your worn or missing grips!