Cable-to-Weight Stack Adapter 1/2-13 Threads

Our cable-to-weight stack adapter bridges the gap between 3/16" cable and the 1/2-13 female threads in the top of the weight stack center selector shaft. Provides a secure and efficient connection. The male 1/2-13 stud is threaded 1.125" long.

You may choose to add an optional 1/2-13 Jam Nut at extra charge.

The hex body has three set screws to secure the cable - 2 set screws on one side, 1 set screw on the opposite side - for maximum holding ability. The set screws require a 3mm Allen wrench to tighten. It is highly recommended that a quality Allen wrench be used to apply a sufficient amount of torque to the set screws. (Bondhus is an excellent choice - made in USA - available on Amazon) This single piece of hardware will replace the 1/2-13 eye bolt, cable thimble, and swaged cable ferrule you may already have in place. Eliminates the need for swaging since an aluminum ferrule isn't needed anymore. Simply cut the cable to the appropriate length, insert into the adaptor, and tighten down all three set screws and you're done!

The cable hole is .200" I.D. (chamfered to protect cable) and is designed to accept up to a 3/16" (.188") cable.

Overall Length: 2.310"
Length of Hex Section: 1.188"
Length of 1/2-13 Stud: 1.125"


Chrome plated finish.